Properties
Use this dialog to configure the measurement device.
- Response status
Standard to be used for measuring color density.
- Filter
Specify whether a UV-cut filter should be used for measuring.
- Illuminant
Standard light source expected to be used for viewing samples of the printed color.
The illuminant selected here determines the white point used for calculating the measurement data.
- Standard observer
Standardized angle of the average human eye at which samples of the printed color are expected to be viewed. This angle determines the field of view and thus the way a person perceives color.
- Measurement method
Light source to be used for illuminating the printed samples during the measurement.
ISO 13655 measurement methods:M0
Traditional non-standardized tungsten light with an undefined UV content
M1
Normal daylight (D50) with a defined UV content
M2
Non-polarized light without any UV content (UV-cut filter)
Note:Measuring color strips in M1 or M2 mode with i1Pro 2 requires the use of a special aluminium ruler. Each row has to be measured twice in opposite directions. The second measurement uses UV light. M0 is the light source used with first-generation i1Pro devices.
- Device signal on
If you disable this option, the device will not send any ‘beep’ signals.